Rush Multibeam 2, User Manual

Page: 8 / 32

8 RUSH Multibeam 2 User Manual
Introduction
The RUSH Multibeam 2™ is a versatile effect featuring two moveable LED
bars, each with 5 individually controllable narrow beams for powerful mid-air
effects. It punches out 10 intense and narrow long-throw beams and features
electronic dimming and strobe effects.
The Multibeam 2 can be controlled via DMX or set to stand-alone operation,
where you can choose from Auto trig (preprogrammed shows) or Music trig
(sound-activated shows). Preprogrammed shows can also be selected via
DMX. Fixtures can be linked together and set to master/slave stand-alone
operation for synchronized stand-alone shows across multiple fixtures.
The fixture is supplied with a 1.5 m (5 ft) power cable (local power plug not
included) and an omega-type mounting bracket.
Before using the product for the first time
1. Read ‘Safety information’ on page 4 before installing, powering, operating
or servicing the fixture.
2. Unpack and ensure that there is no transportation damage before using
the fixture. Never attempt to operate a damaged fixture.
3. If the fixture is not going to be hard-wired to an AC mains power source,
install a local power plug (not supplied) on the end of the supplied power
cable.
4. Before operating, ensure that the voltage and frequency of the local power
supply match the mains power requirements of the fixture.
5. Check the Martin Professional website at www.martin.com for the most
recent user documentation and technical information about the fixture.
RUSH by Martin™ user manual revisions are identified by the revision
letter at the bottom of the inside cover.
Note that whenever AC mains power is applied to the fixture, it will reset all
effects and functions to their home positions. The LED bars will move. This
process usually takes around 20 seconds.