RUSH MH 4 Beam User Manual
19
4. Press ENTER to confirm and power the lamp on or off (or to return to the
previous level of the menu structure without making a change, press
MENU).
State/power on
To set the lamp to power on automatically when the fixture is powered on:
1. Select LAMP SETTINGS and press ENTER to confirm.
2. Use the DOWN and UP buttons to select STATE/POWER ON and press
ENTER to confirm.
3. Use the DOWN and UP buttons to select ON or OFF.
4. Press ENTER to confirm (or to return to the previous menu level without
making a change, press MENU).
DMX lamp control
The lamp can be controlled remotely by DMX. The following options are
available:
•
OFF VIA DMX allows the lamp to be powered off by sending a DMX
command.
•
ON IF DMX ON sets the lamp to power on automatically as soon as a
DMX signal is present.
•
OFF IF DMX OFF sets the lamp to power off automatically as soon as a
DMX signal is not present
Ignition delay
If a large number of fixtures power their lamps on at the same time, voltage
drops can result. To spread the load across multiple fixtures, an ignition delay
of 0 to 255 seconds can be set, so that there is a delay between power on and
lamp on.
1. Select LAMP SETTINGS and press ENTER to confirm.
2. Use the DOWN and UP buttons to select IGNITION DELAY and press
ENTER to confirm.
3. Use the DOWN and UP buttons to specify a delay duration in seconds.
4. Press ENTER to confirm (or to return to the previous menu level without
making a change, press MENU).
Low-power delay
In a low-power delay, when a lamp off command is sent the lamp runs at half
power for a period before powering completely off:
