EN
9
4.
Mounting the control handlebar see fig. C6:
On the surface of the holder 3, the control handlebar 2 is fixed over which the
guide plate 1 is added, through which the two nut screws pass. Squeeze the
two nutes vigorously with about 20-25 daNm.
5.
Mounting commands on handlebars see fig C7:
Mount the throttle 1 on the right side of the handlebars with a screw and nut.
On the left side of the handlebars mount lever 3 forthe placement of the wheels.
The installation is done by means of the screw and nut in Figure C7.
In the body of the lever 2 the actuating cable of the mowing barea after which
you must fasten the lever with the screw and nut to the surface of the
handlebars in the figure. Check the functionality of lever 3 and lever 2 as shown
in Figure D1, acting on each one and they returnar to theposition shown in the
fig. D1. Still in the fig. D1 you have two arrow indicators for the two cables that
Summary of Contents for Scythe DAC 777K
Page 1: ...RO MOTOCOSITOARE CU MASĂ DAC 777K ...
Page 25: ...EN SCYTHE MOWER DAC 777K ...
