EN
12
2. The use of an inadequate oil may result in the opening of the spark plug, clogging of
the discharge or the flu of the piston segs.
3. Move at least 3 metres away from the power point before starting the engine.
4. The use of inadequate fuel will cause severe damage to the internal parts of the engine
shortly.
7. PRE-OPERATION CHECKS
1.
Check that all screws are tightened and adjust them if necessary.
2.
Check each handlebar lever to check their functionality. If the handle positions
are incorrect, adjust them to be in the appropriate positions.
3.
Filling the oil.
-
Fill the engine oil bath with RURIS 4T-MAXlubricationoil.
-
Place the machine on a flat surface while feeding.
-
To check the level of oil use the oil dipstick, the oil must be at
maximum level.
-
Check for oil leaks.
4.
Clean the unit of dust and dirt, especially the air filter.
8. COMMISSIONING
IMPORTANT!
For the first use of the equipment it is absolutely necessary to check that
there is lubricating oil inside the chassis. Do not turn on the equipment before doing this
check. For more information please read the Oil Supply
chapter.
Take the throttle (1) to the Start position, to the operator, thus starting the engine. Adjust
the lever to reach the number of rotations you want.
Lower the lever 6 to activate the mowing bar, while pulling the 8 command lever to
advance the mower. In the event of an unforeseen obstacle, the two control levers (6-8)
must be released immediately. Once the work is done, the engine must be switched off
to stop the engine, carry the accelerator lever 1, in the
STOP
position, to the engine.
LAME REGULATORY (Fig. C1)
Summary of Contents for Scythe DAC 777K
Page 1: ...RO MOTOCOSITOARE CU MASĂ DAC 777K ...
Page 25: ...EN SCYTHE MOWER DAC 777K ...
