Note:
Anytime you wish to restart the robot mower you must move it near to the boundary wire, max. 2 meters’ distance.
Once you have turned off the power, you must place the robot in the docking station for manual restart.
Stage
Symptom
Possible Cause
Action
The robot mower
runs outside the
boundary wire
and stops close
to it.
Wheels, especially the rear drive wheels,
may have a poor grip if covered with mud
and other debris.
In case of bad turning conditions, slopes
or wet grass near the boundary wire, the
robot mower may tend to slip across the
boundary wire while turning direction.
The detection function of the boundary
wire does not work properly.
Clean the wheels of the robot mower and repair
or clean your lawn.
Your boundary wire is too close to the edge of the lawn.
We suggest that you move the boundary wire inwards for
security reasons.
Please refer to “Planning”.
Regular
operation
Big noise and
vibration.
The blades have become unsharp and
the cutting system is unbalanced.
The blade disc was damaged hitting a
hard object.
The nuts for fastening the blade disc
have loosened.
Reverse or replace the blades depending on the
situation. It is important to reverse or replace all
blades at the same time.
Replace the blade disc.
Fasten the nuts firmly.
The regular time
of working after
each charging
has become
shorter.
Dirty charging tentacles of docking station.
Dirty charging copper eyes of robot mower.
Clean charging tentacles and copper eyes.
Battery capacity is reduced after
repeatedly charging and discharging
It is time to buy a new battery in order to obtain a
high efficiency.
The robot mower
does not start
routinely after
previous activation
of rain sensor.
The rain sensor remains activated.
Clean the two metal contacts.
15
MANUAL ·
RURIS RXR1000/RXR1500
