Ruris RX300S, Manual

Page: 114 / 200

EN
23
Do not fill over the limitthe oil bath. If you put above the maximum level the following
effects may occur:
1. Smoking
2. Heavy start
3. Spark plug anchorage
4. The oil can reach the air filter.
Fuel recommendations:
Use clean, fresh, unleaded gasoline.
Do not mix the oil with gasoline.
Check the fuel level.
Before refueling, allow the engine to cool for 2 minutes., clean around the filling hole
before removing the tank cap.
10. PROBLEM GUIDE
Problems Cause Remedies
The engine
does not start
○ The stop handle of the knife is
disconnected
○ Spark plug disconnected
○ Deregulated accelerator cable
○ The tank is empty or the fuel is
obsolete
○ Gasoline flap blocked
○ Spark plug or defective spark plug
○ Motor drowned
○ Tighten the stop handle of the knife
○ Connect the spark plug sheet
○ Check the cable source
○ Fill the tank or change the fuel
○ Clean the gas flap
○ Clean the holes or change the plug
or spark plug
○ Ventilate the combustion chamber
The engine
operates with
speed
fluctuations
○ The machine goes to the starting
position
○ Ignition interrupted
○ Locked petrol valve or obsolete fuel
○ Water or fuel mess
○ Clogged air filter
○ Machineburetor deregulated
○ Change gear quickly (fast)
○ Connect and tighten the spark plug
○ Clean the valve and fill the tank with
fuel
○ Empty the tank and replace the fuel
○ Clean the air filter or replace it.
○ Adjust the machineburetor
Overheated
engine
○ Engine oil below level
○ Small air circulation
○ Machineburetor not regulated well ○ Change the oil or fill it out
○ Clean the cooling spaces
○ Adjust the machineburetor