Ruris RX300S, Manual, Page: 115 / 200

EN
24
Motor speed
interruptionsr
at high
speeds
○ Clogged machineburetor
○ Defective spark plug
○ Spark plug or faulty cable ○ Clean the machineburetor
○ Replace the spark plug
○ Replace the sheet or ignition
Vibration
excessive
○ Loose cutting knife or unbalanced
machine
○ Tighten the adapter knife
○ Check the balance of the knife
○ Change the knife.
The machine
does not cut
the lawn
○ engine speed too low
○ Wet
○ Lawn too high
○ Damaged knife (unsharp) ○ Adjust the machineburetor or the
lever of the controller (service).
○ Do not cut the lawn when wet, wait
until it dries.
○ Cut once high then cut again to the
desired height
○ Sharpen or replace the knife
Unmatched
cut
○ Wheels not well positioned
○ Used knife ○ Place all wheels in the same position
○ Sharpen or replace the knife
NOTE: For repairs outside the above adjustments, contact the nearest RURIS authorized
service
11. STORAGE
The next steps should be followed to prepare the lawn mower for storage.
●
Clean and lubricate the machine machineefully after the description in the
instruction manual.
● Wrap the machine knife with Vaseline to prevent rust.
● Store the machine in a dry, clean area. Do not store it next to corrosive material or
heating sources (central, stoves).
● Empty the fuel from the tank.
● Turn on the machine and let it run until the machineburetor fuel is consumed and
stopped.