EN
14
Step 5: Set the "ON / OFF" switch to the "ON" position and make sure that the LED
indicating the power source lights up.
Step 6: Switch the device to Flux mode
Step 7: After completing the welding process, remove the MIG gun from the ground
source, put the mask down and set
the “ON / OFF” switch to the “OFF” position.
5.5 WIRE COIL INSTALLATION:
1. Open the protective cover of the device.
2. Loosen the coil support nut, remove the spring and the securing sleeve.
3. Place the coil on the stand taking into account its direction of rotation.
4. Install the mounting sleeve, spring and nut in the reverse order of disassembly.
