EN
10
For MMA welding:
Step 1: Connect the power cord to a power source.
Step 2: Connect the "B" ground clip to the negative (-) terminal and the workpiece.
Step 3: Mount the electrode in the “A” electrode holder clamp, then connect the clamp to
the positive (+) terminal.
Step 4: Set the "ON / OFF" switch to the "ON" position and make sure that the LED
indicating the power source lights up.
Step 5: Switch the device to MMA mode
Step 6: Make sure that the intensity of the welding current is adequate for the thickness
of the workpiece and the electrode.
Step 7: After completing the welding process, remove the electrode from the ground
source, put the mask down and set the “ON / OFF” switch to the “OFF” position.
Approximate data on welding current and electrode diameter
Electrode diameter
1.6 mm
2.5 mm
3.2 mm
Welding current
30-80A
60-100A
80-140A