EN
12
5.3 MIG WELDING
Solid wire (CO2 or MIX, gas mixture)
For this type of welding, use the MIG gun "D”
Step 1: Connect the power cord to a power source.
Step 2: Connect the "B" ground clip to the negative (-) terminal and the workpiece.
Step 3: Connect the polarity cable to the positive terminal.
Step 4: Connect the device to the gas cylinder.
Step 5: Set the "ON / OFF" switch to the "ON" position and make sure that the LED
indicating the power source lights up.
Step 6: Switch the device to CO2 mode
Step 7: After completing the welding process, remove the MIG gun from the ground
source, put the mask down and set
the “ON / OFF” switch to the “OFF” position.
B
D
