RG-EasyGate Series Hardware Installation Guide V1.28
Starting and Configuring the Breakout Gateway
Starting a Breakout Gateway
Building Configuration Environment
When the breakout gateway is used for the first time, you must configure the breakout gateway via the console port as
follows:
Step 1: Connect the serial port of a character terminal or a microcomputer to the console port (or configuration port or
control panel port) of a breakout gateway via a standard RS232 cable.
Step 2: Configure the communication parameters of the terminal. If you use a microcomputer, you need to run the terminal
emulator like the Hyperterm program provided by Windows operating system. We will describe the operating procedures
by taking the example of Hyperterm.
Run Hyperterm software and establish a new connection, as shown in Figure 4-1;
Select the serial port connecting with the console port of the breakout gateway, as shown in Figure 4-2;
Configure the communication parameters: 9600 baud rate, 8-bit data bits, 1-bit stop bit, no parity check, and no flow
control, as shown in Figure 4-3;
Choose
File
>
Attribute
>
Setting
and select the terminal emulation type of VT100; all as shown in Figure 4-4:
Figure 4-1 Establish a New Cconnection
Figure 4-2 Select the Serial Port of Microcomputer Connecting with the Console Port of Breakout Gateway
Figure 4-3 Configure the Communication Parameters of the Serial Port
