User
’
s Manual of RDC6442G(U)-DFM-RD Control System
SHENZHEN RUIDA TECHNOLOGY
50
9.2 User parameters
（
1
）
Cutting parameters(Only affect cutting arts)
Idle Move Speed
: this parameter decides the highest speed of all non-lighting
lines for the machine in the movement process.
Idle Move Acceleration
: it means the highest acceleration of all non-lighting
lines. Idle stroke speed and idle stroke acceleration can be set higher to reduce the
working time of the whole figure, but if they are set too high, it may cause the jarring of
track, so comprehensive consideration should be given to the setting.
Idle Move Delay
：
If this parameter is zero, then after idle moving there is no
delay, or, there is delay and the speed will decrease to turn off speed.
Turning Speed
: it means the speed of turning at the acute-angle corner, which
is also the highest speed in the whole cutting process.
Turning Acceleration
: it means the acceleration of turning at the acute-angle
corner when cutting. If the two speeds are set too high, jarring will happen to the turning;
if set too low, it will influence the cutting speed. This acceleration is the least value of the
whole graph.
Cutting Acceleration
: it means the highest acceleration value in the whole
cutting process.
Acc Factor
: This parameter indicates how speedy the cutting acceleration is
changing.
G0 Acc Factor
: This parameter indicates how speedy the idle move
acceleration is changing.
Speed Factor
: This parameter indicates the cutting speed of the arc of various
curvatures.
●
Key Setting
: This is a button but not a parameter, this button is used to recommend
some experiential cutting parameters.
（
2
）
Scanning parameters(Only affect scanning arts)
X-axle Starting Speed
Y-axle Starting Speed
X-axle Acceleration
Y-axle Acceleration
The above four parameters are used to set the starting speed and acceleration of
two axles on the scanning. The higher the two speeds are, the quicker the scanning is.
Scanning Line-feed Speed
: this parameter is specially used to control the
highest speed at which that the previous line vertically moves to the next line in the
scanning mode. If the space between lines is larger during the scanning or if the
distance of each block is larger during the scanning and deblocking of figure, it is
necessary to position each line or block accurately. In such a case the speed of
scanning line-feed can be set as a lower value.
Scanning Mode
: it is divided into general mode and special mode for option. If
special mode is used, the laser power should be increased. The smaller the speckle
