User
’
s Manual of RDC6442G(U)-DFM-RD Control System
SHENZHEN RUIDA TECHNOLOGY
34
8.2.4 Set the layer parameters
After selecting a file to preview on the main interface, user can push “Enter” key to let the cursor
move to the first layer, then “Y+/-” Keys can be pushed to select the intent layer, on that time, user
can push “Enter” key to check the selected layer’s parameters, show as below:
User can push “Z/U” Keys to move the green block on the intent parameter, then he could change
the parameter if needed. “OK” to validate the change, and “Esc” to invalidate the change.
8.3
Z/U Key
The Z/U key can be pressed when the system is idle or the work is finished. On pressing this key,
it will show some entries in the following interface:
Figure 8.2-5
Figure 8.2-6
