Cutting machine SR 1 / SR 1 Turbo
15
machine must be shut down in the event of any damages or
changes!
5.2
Regular maintenance
Regular maintenance of the machine must be carried out every 2000
hours of operation but at least once per year.
Maintenance schedule:
a)
Inspect the safety devices as outlined in Chapter 1.1 Safety
Instructions!
b)
Test run with open machine (caution: moving parts)!
c)
All inspection activities and resharpening tasks specified
under “Regular Care”!
d)
Check the synchronism of the eccentric shafts; adjust if
necessary!
e)
Check the distance between cut-off knife and grate frame;
adjust if necessary!
f)
Inspection of the main coupling and freewheeling bearings!
g)
Checking the pre-pressing function and the safety clutch!
h)
Checking the feed settings!
i)
Check radial shaft seals for leak tightness; replace otherwise!
j)
Grease all lubricating nipples and moving parts in the
machine compartment!
k)
Read operating hours!
5.3
Repair and spare parts
As a damaged part on a machine is usually damaged due to causes
unrelated to the part, always carry out a fault diagnosis.
For this reason, contact our Service Hotline at +49 7748-523-11 for
spare parts or technical faults. Please keep the machine type and
number ready.