RuggedCom RuggedSwitch RSG2300, Installation Manual

Page: 35 / 52

RUGGEDCOM RSG2300
Installation Guide
Chapter 4
Communication Ports
GBIC Optic Ethernet Ports 25
SFP Transceiver Order Code
Speed
(Mbit/s)
Mode
a
Nominal Distance (km)
RUGGEDCOM SFP1132-1LX70 6GK6000-8FG54-0AA0 1000 SM 70
RUGGEDCOM SFP1132-1LX100 6GK6000-8FG55-0AA0 1000 SM 100
RUGGEDCOM SFP1132-1LX115 6GK6000-8FE56-0AA0 1000 SM 115
a
MM = Multi-Mode, SM = Single-Mode
b
The RUGGEDCOM RSG2300 supports only 100/1000 Mbit/s.
Section 4.4
GBIC Optic Ethernet Ports
GBIC (Gigabit Interface Converter) optic Ethernet ports are available with SC (Standard or Subscriber Connector)
connectors.
2 1
Figure 21: SC Port
1. Tx Connector 2. Rx Connector
CONTENTS
• Section 4.4.1, “Installing a GBIC Optical Port”
• Section 4.4.2, “Removing a GBIC Optical Port”
Section 4.4.1
Installing a GBIC Optical Port
To install a GBIC optical port, do the following:
CAUTION!
Electrical hazard – risk of damage to equipment. Use only components certified by Siemens with
RUGGEDCOM products. Damage to the module and device may occur if compatibility and reliability
have not been properly assessed.
CAUTION!
Electrical hazard – risk of damage to equipment. Make sure all electrostatic energy is dissipated before
installing or removing components from the device. An electrostatic discharge (ESD) can cause serious
damage to the component once it is outside the chassis.