T504 AP Installation Guide, 800-71032-001 Rev D
Installing the T504
Deploying the T504
21
Deploying the T504
In this section, you will mount the T504 in its final mounting location. Perform the following:
o
o
o
Installing the Cable Power Tap
o
o
Checking the T504 Signal Level with an RF Power Meter (Optional)
o
Configuring the T504 for the First Time (Optional)
Mounting the T504
To mount the T504 assembly on a cable strand, you need to secure the cable clamps that are
attached to the strand interface to the cable strand.
1
Slightly loosen the nuts that fasten the two cable clamps to the strand interface, enough for the
strand support cable to fit into the cable clamps.
2
Place the cable clamps on the strand support cable.
3
Tighten the two cable clamp nuts to 22 to 27N.m (16 to 20 ft-lbs) to secure the mounting.
You have mounted the T504. Continue with
Summary of Contents for ZoneFlex 901-T504-US31
