Ruck ETA K 1200 F O, Assembly And Operating Manual

Page: 55 / 68

55
English
www.ruck.eu
16. Appendix
16.1. List of parameters
The following table lists all of the parameters that are displayed on the control unit, some of which
may be changed. Section 9.3.4. „Parameter settings menu“ gives full instructions on operating and
setting the corresponding parameters.
No. Consequence Range of values Factory setting
P 1 Mini.set-point temp. that can be set on the control unit 10 °C ... 20 °C 16 °C
P 2 Max. set-point temp. that can be set on the control unit 20 °C … 35 °C 22 °C
P 3 External release AUTOMATED
ACKNOWLEDGED
AUTOMATED
P 4 I - component 5 ... 20
10
P 5 P - component 5 ... 20 10
P 6 Temp. correction of the ambient temp. sensor on the control unit -5 °C ... 5 °C 0
P 7 Address 1 - 247 1
P 8 Baud rate 2400 / 4800 / 9600 / 14400 / 19200
9600
P 9 Fan calibration supply air 800 - 1200 1.000
P 10 Fan calibration extract air 800 - 1200 1.000
P 13 Type S / PV / P S
P 14 Sensor type CO2 / VOC / EXT.CTRL. / HUMIDITY Units / Model
P 15 Minimum ventilation supply air
P 16 Minimum ventilation extract air
P 17 Basic ventilation supply air
P 18 Basic ventilation extract air
P 19 Intermittent ventilation supply air
P 28 Intermittent ventilation extract air
P 20 Air quality CO2 / VOC / r.F 1400 ppm / 45 %
P 21 Type of regulation SUP.AIR TEMP.CON / ETA TEMP.CTRL /
ROOMTEMP.CONTROL
SUP.AIR TEMP.CON
P 22 Selection of heating system
HEATING / COOLING / HEATING-COO -
LING DIRECT EVAPORATO
HEATING
P 23 Sensor measuring range min. 0 ppm
P 24 Sensor measuring range max. 2000 ppm
P 25 Supply air filter 0 - 500 Pa 100 Pa
P 26 Extract air filter 0 - 500 Pa
100 Pa
P 27 Calibrate filter
P 29 ETAK TYPE HW / HE / VW / VE / FW / FE
P 30 Extended running time 1 - 60 mins 5 MIN.