OPERATING INSTRUCTIONS
1) Connect ZW-PRO to a laptop:
• Plug the ZW-PRO into the USB connector of a
laptop computer.
NOTE: While connected to a computer the ZW-
PRO is always listening for instructions and will
respond to commands sent through USB by the
configuration software.
2) Open Z-Wave configuration software
• Open the Z-Wave network configuration
software which takes control of the ZW-PRO.
3) Factory reset the ZW-PRO
IMPORTANT:
If the ZW-PRO had been used to
configure a different Z-Wave network previously,
the devices and settings from that system need
to be cleared out or they will be added to the
current system being installed.
• Factory reset on the ZW-PRO: This must
be done through the configuration software
which takes control of the ZW-PRO while it
is connected to the computer. Please consult
the configuration software instructions to
perform a reset.
4) Add the ZW-PRO to Z-Wave Network
• This must be done through the configuration
software while the ZW-PRO is connected to
the computer. Please consult the configuration
software instructions to add the ZW-PRO to a
Z-Wave network (i.e. “Learn mode”, “Add as
Secondary Controller”, etc.).
5) Inclusion-Mode: Adding/Including
devices into the Z-Wave network
• Place the laptop with the ZW-PRO connected
within range of the device to be “included”
into the Z-Wave network.
• This must be done through the configuration
software while the ZW-PRO is connected to
the computer. Please consult the Z-Wave
Manager configuration software instructions
to perform an inclusion or removal of Z-Wave
devices. (Example functions: “Add”, “Include”,
“Pair”, “Remove”, “Include”, etc.).
IMPORTANT:
The wireless communication
range of devices varies. Devices such as security
products and door locks typically have very
short wireless range prior to being configured
for security purposes. Please consult the
instructions of the device.
