rtd cpuModule CMC6686GX, User Manual

Page: 82 / 118

81
Power On Self Tests (POSTs)
POST Messages
During the Power On Self Test (POST), if the BIOS detects an error requiring you to do something
to fix, it will either sound a beep code or display a message.
If a message is displayed, it will be accompanied by:
PRESS F1 TO CONTINUE, CTRL-ALT-ESC OR DEL TO ENTER SETUP
POST Beep
Currently there are two kinds of beep codes in BIOS. This code indicates that a video error has oc-
curred and the BIOS cannot initialize the video screen to display any additional information. This
beep code consists of a single long beep followed by three short beeps. The other code indicates that
your DRAM error has occurred. This beep code consists of a single long beep repeatedly.
Error Messages
One or more of the following messages may be displayed if the BIOS detects an error during the
POST. This list includes messages for both the ISA and the EISA BIOS.
CMOS BATTERY HAS FAILED
CMOS battery is no longer functional. It should be replaced.
CMOS CHECKSUM ERROR
Checksum of CMOS is incorrect. This can indicate that CMOS has become corrupt. This error may
have been caused by a weak battery. Check the battery and replace if necessary.
DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER
No boot device was found. This could mean that either a boot drive was not detected or the drive
does not contain proper system boot files. Insert a system disk into Drive A: and press <Enter>. If
you assumed the system would boot from the hard drive, make sure the controller is inserted correct-
ly and all cables are properly attached. Also be sure the disk is formatted as a boot device. Then re-
boot the system.
DISKETTE DRIVES OR TYPES MISMATCH ERROR - RUN SETUP
Type of diskette drive installed in the system is different from the CMOS definition. Run Setup to
reconfigure the drive type correctly.
DISPLAY SWITCH IS SET INCORRECTLY
The display switch, on the motherboard, can be set to either monochrome or color. This indicates the
switch is set to a different setting than indicated in Setup. Determine which setting is correct, and
then either turn off the system and change the jumper, or enter Setup and change the VIDEO selec-
tion.
DISPLAY TYPE HAS CHANGED SINCE LAST BOOT
Since last powering off the system, the display adapter has been changed. You must configure the
system for the new display type.
EISA Configuration Checksum Error
ERROR ENCOUNTERED INITIALIZING HARD DRIVE
Hard drive cannot be initialized. Be sure the adapter is installed correctly and all cables are correctly
and firmly attached. Also be sure the correct hard drive type is selected in Setup.
ERROR INITIALIZING HARD DISK CONTROLLER