rtd CMV6486DX100HR, User Manual

Page: 22 / 118

22
Default Configuration
Jumper JP5 is used to ensure that you can always get into setup, even if you disable the keyboard
and display. The jumper should not be installed for normal operation. When JP5 is installed it forc-
es the cpuModule to ignore all user setup information and boot with the default values outlined in
the following table. With JP5 installed you can do two things:
• boot the cpuModules from a floppy disk
• press <Del> to run the Setup program and re-configure the cpuModule
This procedure is described in more detail at the end of this chapter.
Highlights of Default Setup
Item Setting Controlled by:
Boot device Floppy Setup
SSD size/type None Setup + jumpers
Memory 16MB Setup
Video EGA/VGA Setup
Floppy Drive 1 1.44M 3.5" Setup
Floppy Drive 2 Not installed Setup
Hard disk Not installed Setup
Failsafe Boot
Rom
Enable Setup
NOTE! When Fail Safe Boot ROM is enabled the cpuModule will boot to the
Book Block Flash exclusively.