Rt IDLV-4000P-30x, User Manual

Page: 13 / 38

En
9
Main menu Sub-menu Description
Inputs
Status Display the status of signal inputs for ASI, TUNER and IP IN:
ASI Input: Locked or unlock indicate the status of the ASI input.
Tuner Input: When the QPSK/QAM/COFDM signal is locked by the tuner, the
bit rate is displayed on the bottom row of LCD.
Ethernet: This indicates the status of the transport stream over IP input. The
bitrate is displayed on the bottom row of the LCD only if IP input is valid (note
this menu is showed only when the TS/IP streaming board is installed and the
board is set to “IP In”, refer to section Optional Function (External Board Type)
under System).
DVB-S2 This menu only is shown on IDLV-4000P-xxS2 model
LNB Frequency: Input LNB frequency
Satellite Frequency: Input downstream frequency of satellite
Symbol Rate:
Input symbol rate of satellite
LNB Voltage:
Select the correct LNB voltage output of the F-connector: Off, 13
V, 18 V. <13V for Vertical/Left hand polarization, 18V for Horizontal/Right hand,
OFF for LNB Power off.>
LNB 22KHz: activate the LNB 22 kHz control signal to the LNB: On or Off.
<22KHz control signal switches the LNB to receive high band if any>
DISQEC: Can select OFF/Port A/Port B/Port C/Port D
QPSK The same as DVB-S2
COFDM This menu only is shown on IDLV-4000P-xxT model
Frequency:
Enter the proper frequency of the COFDM signal in MHz.
Bandwidth:
Set the bandwidth from 6M/7M/8M
QAM This menu only is shown on IDLV-4000P-xxC model
Constellation:
Enter the modulation mode of the QAM signal.
Frequency:
Enter the frequency of the QAM signal in MHz.
Symbol Rate:
Edit the symbol rate to the proper value in KBaud.
RSSI Display the quality of received DVB-S/S2 signal.
Ethernet This menu is part of the IDLV-4000P-44xx model, which sets TS/IP streaming
board as “IP IN”
Stream IP Addr: Enter the IP address for streaming IP input of the unit.
Stream Netmask: Enter the network sub mask for the subnet to which the unit
is connected for IP streaming traffic.
Stream Gateway: Set the gateway for the network to which the unit is con-
nected for IP streaming traffic.
Stream Mac Address: Factory-set MAC addresses are guaranteed to be
unique. Therefore you cannot configure the address.
Multicast IP Addr:
Enter the IP address of the multicast stream for the trans-
port stream over IP.
Multicase UDP Port:
Enter the UDP port number of the TS over IP stream.
Protocol: select the protocol for multicast: UDP or RTP.
Output Smoothing: Set the quality of TS which comes from the TS/IP input.
Auto: The bit rate is variable.
Disable: The unit let the TS pass by.
Fixed Rate: The bit rate is fixed.
TS Bit Rate: Set the bit rate of the TS comes from the TS/IP input. The setting
is only valid when the output smoothing is configured as Fixed Rate.