RSP P6411, Product Manual

Page: 35 / 42

M0619-1 ver 2.6 35
4.5 Replacement of wear parts
4.5.1 Replacement of air sealings
4.5.2 Replacement of signal pins (TC250-8E only)
Replace a signal pin when the spring jams, or become bent.
Action Note
1 Remove air sealings Remove the air sealings with a screw driver.
NOTE! There are totally 8 air sealings.
2 Clean sealing holes Wipe clean the sealing holes. Remove all
remaining parts of the sealings.
3 Mount air sealings Tap in the new air sealings with a plastic
mallet.
Action Note
1 Power off Switch the power off and lock the circuit
breaker.
2 Remove signal pins Pull out the signal pins with a pair of pliers.
NOTE! There are totally 20 signal pins.
3 Replace signal pins Fit the new signal pins by pushing them into
the sleeves.
NOTE! The signal pins must be individually
pressed fully into the sleeves using a small
screw driver!
4 Power on Unlock the circuit breaker and switch the power
on.