22
Switch GREEN
Sensor
AC, DC, or DCC trains can be controlled.
Make sure to program the YardMaster for the desired time delay.
Program a lap count if desired.
When the power supply is turned on the train should run. If it does not then press the
Alternate button. This is a one-time operation since the YardMaster will remember the switch state in
memory.
Change direction of the train as desired. The YardMaster will operate in both directions.
Adding a signal light is optional, but adds to the fun.
For gradual decelerations and accelerations consider using a StationMaster for a station stop
.
Station Stop Hookup Diagram for a Remote Track Section
Place MAGNET
on bottom of engine.
Track power provides
power to YardMaster
Isolators, 2 places
Station Stop with Sensors
Train
Sensor
Attach
to
Track
RRConcepts.com
1
2
3
4
5
6
20
19
18
17
16
15
7
11
8
12
9
13
14
Parts List
YardMaster 1
Track Isolators 2
Train Sensor 1
Train magnet 1
wire as required
This is basically the same hookup as a standard station stop in a loop
however it uses the track power as the voltage input to the YardMaster.
Add this to a remote location on your railroad without stringing wires to the
remote section. Trains can run in either direction Track power must be 8 volts or more..
The sensor provides an exact stopping location. A train magnet is required.
