18
To
Power Pack
TRACK
Terminals
Attach to
TRACK
anywhere
Station Stop Hookup Diagram
Place MAGNET
on bottom of engine.
Add additional sensors in PARALLEL
for additional station stops.
For a simple station stop, this is all you need to do!
Make sure to program the YardMaster for the desired time delay.
When the power supply is turned on the train should run. If it does not then press the
Alternate button. This is a one-time operation since the YardMaster will remember the
switch state in memory.
Change the direction of the train as required. The YardMaster will operate in both directions.
Adding a signal light is optional, but adds to the fun. Attach to signal light terminals.
Switch GREEN
Sensor
8 & 9
RED Relay
Terminals 17 & 18
Station
Stop using sensors
Common
Relay
Terminals
3 & 4
Programming:
* Set time delay as
desired.
* Set lap count as
desired.
YardMaster Power
DC trains only.
See power page
for AC trains using
wall wart.
RRConcepts.com
1
2
3
4
5
6
20
19
18
17
16
15
7
11
8
12
9
13
14
