10
Programming the Operating Mode
The YardMaster can be programmed
to control different types of turnouts
(electric switches), or disable the
realistic signal light blinking feature.
All programming is stored in flash memory and retained until re-programmed.
To program the YardMaster perform the following:
1.
Enter Programming Mode:
Press the ALTERNATE and either one of the Switch RED or Switch GREEN buttons simultaneously.
The YardMaster will turn BLUE when in programming mode.
2.
Program the operating mode:
Press and hold down the Alternate pushbutton for the desired number of blinks
.
The blink count corresponds to the following table.
To exit programming mode quickly press the Alternate button.
1 Control LGB style turnouts (electric switches)
This is the default setting after a factory reset.
2 Control SLOW_MOTION turnouts (electric switches)
These include Tortoise, Aristocraft slow motion, etc.
3 Synchronize Auxiliary relay to internal relay. (Can not use with 3 wire switch
motor control)
4 Directly control Railroad Crossing signals
Alternately flash the lamp outputs to directly control lamps or LED’s.
5 Disable signal light flashing for LGB style turnouts.
This is required if the signal lamp already has flashing circuitry.
6
Disable signal light flashing for SLOW MOTION turnouts.
Control Pneumatic turnouts by keeping the output voltage on continuously.
This is required if the signal lamp already has flashing circuitry.
7 Alternate the auxiliary relay when switching to RED
Provides control for bi-direction operations with alternating trains. See hookup.
Keep pressing the Alternate button for 10 seconds to force a Factory Reset
RRConcepts.com
1
2
3
4
5
6
20
19
18
17
16
15
7
11
8
12
9
13
14
