9
To perform a factory reset:
1. Enter Programming Mode: (Remove any jumpers if present)
Press the ALTERNATE button and either one of the Switch RED or Switch GREEN buttons
simultaneously.
The YardMaster will display BLUE when in programming mode.
2. Press and hold the ALTERNATE pushbutton
The
for at least 10 seconds.
YardMaster will slowly flash the blue sensor LED many times but keep holding down
the button. After a delay the blue status LED will twinkle to indicate a factory reset.
Release the button.
Factory Reset
.
A factory reset will set the following:
Turnout control for LGB style turnouts (electric switches).
Time delay OFF
Lap count: 1
Signal lamp flashing enabled
Node ID: “1”
.
RRConcepts.com
1
2
3
4
5
6
20
19
18
17
16
15
7
11
8
12
9
13
14
Hold this button down for 10 seconds
Blue LED will twinkle when done.
