RPM MPQ Series, User Manual, Page: 34 / 48

RPM Systems Corporation
March, 2016 Page 34
MPQ Manufacturing Programmer User's Guide
The following drawing shows the target system connections required for programming of devices on the
Z8-Encore! target board using the MPQ. Connection of the RESET signal is optional but recommended.
MPQ
Target
Connector
Pin #
Signal
Name
Signal Description Wire Color
Zilog
DBG Pin
#
1 - Not Used
2 Vcc Target Vcc Red 1
3 -
Not Used
-
4 DBG Target Debug signal Yellow 4
5 RESET Target Device Reset Violet 2
6 -
Not Used
-
7 -
Not Used
-
8 GND
Target GND
Black 3
9 Vcc Target Vcc Red 1
10 -
Not Used
-
11 DBG Target Debug signal Yellow 4
12 RESET Target Device Reset Violet 2
13 -
Not Used
-
14 -
Not Used
-
15 GND Target GND Black 3
16 Vcc Target Vcc Red 1
17 -
Not Used
-
18 DBG
Target Debug signal
Yellow 4
19 RESET Target Device Reset Violet 2
20 -
Not Used
-
21 -
Not Used
-
22 GND Target GND Black 3
23 Vcc Target Vcc Red 1
24 -
Not Used
-
25 DBG
Target Debug signal
Yellow 4
26 RESET Target Device Reset Violet 2
27 -
Not Used
-
28 -
Not Used
29 GND
Target GND
Black 3
30 - Not Used
Ta
rg
e
t P
o
rt
4
MPQ-Z8 Target Cable Connections
Ta
rg
e
t P
o
rt
1
Ta
rg
e
t P
o
rt
2
T
a
rg
et
Po
rt
3
NOTE: The GND signal must be common amongst the four target ports when connected to the
programmer. All GNDs are tied together internal to MPQ.