RPB Vision-Link, Instruction Manual, Page: 7 / 24

7
Insert the mounting bracket into the jaw,
lining up the holes. Insert and tighten the
mounting screws. Remove the mounting bracket from the light
unit if they came attached.
INSTALLATION TO T-LINK
®
FIGURE 2.1
FIGURE 2.2
FIGURE 2.3
Reattach the light unit to the mounting
bracket by inserting the hinge bolt through
the holes in the mounting bracket and the
washer, into the nut in the lever.
FIGURE 2.4
With the lever open, slide the Vision-Link
unit into the slots of the mounting bracket,
onto the hinge bolt. Adjust the light to the
desired angle and close the lever to tighten
in place. You may need to open the lever
and tighten or loosen the hinge bolt to get
the correct tightness when the lever is
closed.