RPB Vision-Link, Instruction Manual, Page: 6 / 24

6
™
WARNING
Only use the light mount designed for the respirator the Vision-Link
™
is to be used with. DO
NOT attach the light with glue, tape, or by any other means to the respirator as it will void
the NIOSH approval for the respirator.
Remove the center cape clip by removing
the screw that holds it in from the inside of
the helmet.
Insert the hinge bolt through the mounting
clip and washer, into the nut in the lever.
Insert the Vision-Link
™
mounting clip and
screw into place from the inside of the
helmet.
INSTALLATION TO Z-LINK ® AND Z4 ®
FIGURE 1.1 FIGURE 1.2
FIGURE 1.3
With the lever open, slide the Vision-Link
™
onto the hinge bolt. Adjust the angle and
close the lever to secure it in place. Adjust
the tightness of the lever by adjusting the
tightness of the hinge bolt.
FIGURE 1.4
SETUP AND CARE