RPB Vision-Link, Instruction Manual, Page: 5 / 24

5
 Ensure that equipment is properly set up, used, and maintained.
Make sure that equipment is properly set up, inspected, fitted, used, and maintained,
including using only RPB ® batteries and chargers made specifically for the Vision-Link ™
Light.
 Dispose of the battery in accordance with local regulations.
 If you have any questions, contact RPB
®
.
 Call Customer Service Department at:
Tel: 1-866-494-4599
Email: customerservice@rpbsafety.com
Web: rpbsafety.com
PRODUCT USER SAFETY INSTRUCTIONS
MAKE SURE THE SYSTEM IS READY FOR USE
Make sure you have a complete unit.
Verify that you have all components for the Vision-Link
™
Light:
 Vision-Link
™
Light
 09-055 Battery
 09-050 Battery charger

The correct light mount for the respirator the light is to be used on
Do not modify or alter any part of this product.
Inspect all components daily for signs of damage or wear and tear. Remove any damaged
component, including the lens or housing that has been subject to impact or other damage, from
service until replaced. Scratched or damaged lenses or other components should be replaced with
genuine RPB
®
brand replacement parts. The lens must fastened securely, as it forms part of the
seal to keep moisture, dust and other debris away from the electrical components inside. Inspect
the battery compartment for moisture, dust or other debris. Keep the battery compartment of the
light clean at all times.
Make sure that the light is correctly assembled. Never use the light without the lens in place.
DO NOT ENTER THE WORK AREA if any of the following conditions exist:

You cannot escape without the aid of the Vision-Link ™ Light in case the battery dies or another
problem occurs.

When flammable or explosive atmosphere is present.
 The temperature is outside the range of 14°F to 140°F (-10°C to +60°C).
PRODUCT CARE
Never place the light on hot surfaces. Do not apply paints, solvents, adhesives or self-adhesive
labels except as instructed by RPB
® . Clean the Vision-Link ™ with mild detergent and a soft cloth
or a disinfectant wipe.