RPB T-Link, Instruction Manual

Page: 16 / 56

16
®
Insert the bayonet end of the breathing tube
into the outlet of the PX5
®
or the PX4 AIR
®
PAPR and twist it in until it is secure.
FOR USE WITH RPB
®
PX5
®
OR THE
PX4 AIR
®
- SEE THE PAPR USER MANUAL
When the T-LINK
®
Respirator is being used
in conjunction with the RPB ® PX5 ® or the
PX4 AIR
®
PAPR, please refer to the RPB
®
PX5 ® or the PX4 AIR ® Instruction Manual
for set up and use of the assembly.
Note: The RPB
®
PX5
®
and the PX4 AIR
®
are Powered Air Purifying Respirators,
therefore care must be taken when
selecting the correct filter for the application
the respirator will be used in.
FIGURE 3.3
POWERED AIR
RESPIRATOR SETUP AND CARE CONTINUED
Without a hood on the T-LINK
®
helmet
assembly, insert the breathing tube adapter
into the inlet of the T-LINK
®
by threading
it in until tight. A wrench may be required.
Be careful not to over tighten and crack the
inlet area of the T-LINK
® .
INSERTING THE BREATHING TUBE
ADAPTOR TO RETROFIT OLDER MODELS
FIGURE 3.1
Install a the T-LINK
®
hood. Line up the
adaptor with the inlet seal. Attach breathing
tube to the adaptor by screwing it on
completely without over tightening. Be
mindful of the hood to keep it from twisting
as the breathing tube is tightened. Breathing
Tube 04-831, 04-833 or 04-837 required.
FIGURE 3.2
ATTACH THE BREATHING TUBE