Roxell HaiKoo, Use And Assembly Manual

Page: 62 / 90

HAIKOO -- INSTALLATION INSTRUCTIONS ROXELL - 009 - 3509
III--12
FIGURE 21.
-- Guide the main cable through the winch.
-- Hook the cable on the drum flange.
-- Make
4 full turns
onthe drum, guide thecable
against the drum flange and make sure that
windings touch each other.
-- Pull the main cable through the bottom hole of the
drum.
--
Always
connect the main cable
with
two
cable clamps.
-- Hook the cable over the recess in the drum (if necessa-
ry use a screw driver and a light hammer).
-- Fix the cable with a set screw. See that you
do not dam-
age
the cable by tightening too much.
-- Make
4 full turns
on the drum,
guide the cable against the drum
flange and make sure
that windings touch each other.
--
Always
fix the main calble
with
two
cable clamps.
-- Stretch the main cable by using counterweights
(e.g. : power units).
A
B
Set screw.
Recess in the drum.
-- Now you can start the complete suspension of the system
-- Start at the end of the circuit.
-- Hang the roll of cable in a support to prevent torsion when unrolling the cable.
-- Pull the cable through the first pulley.
-- Unroll the cable towards the winch until you have the required length.
TO INSTALL THE MAIN CABLE
CONSIDER THE DOUBLE DIVERSION !! ONLY THEN INSTALL THE CABLE. YOU CAN HANG THE
MAIN CABLE IN THE SCREW HOOKS FOR THE TIME BEING.
AFTER INSTALLING THE SUSPENSION CABLES, MAKE SURE THAT THE CABLE RUNS ALONGSIDE
(NOT THROUGH) THE SCREW HOOKS AND THE PULLEYS. THE MAIN CABLE RUNS ONLY THROUGH
THE HEAVY DUTY PULLEYS AND THE PULLEYS AT BOTH ENDS OF THE CIRCUIT.