Roxell HaiKoo, Use And Assembly Manual

Page: 53 / 90

ROXELL - 009 - 3911 HAIKOO -- INSTALLATION INSTRUCTIONS
III--
1.
Be
CAREFUL
when handling the
ROLLS OF AUGER
.
--
When you release the
BINDING WIRE,
it is possible that the auger
UNROLLS
. This
can cause injuries.
--
ALWAYS
use
SAFETY GLOVES
when you slide the auger into the tube.
--
ALWAYS
see that the auger
CANNOT SPRING BACK
(by using clamps) when you
put it under tension .
2.
Check all
TUBE CONNECTIONS
and all
TUBE CLAMPS
on control units, feed intake
boots and bearings for
PROPER CLAMPING.
Tighten all tube clamps with a
TORQUE
of min. : 10Nm.
3. TEST
the
SUSPENSION SYSTEM
for safe operation :
--
Firmly fasten the
WINCH
and the
SUSPENSION POINTS
. Firmly tighten
ALL
CABLE CLAMPS
.
--
WINCH UP THE FEEDER LINES THREE TIMES
and lower them again (full
course).
NEVER STAND UNDERNEATH THE SYSTEM
when doing this.
--
Winching up and lowering must proceed
WITHOUT ANY HITCH
.
4.
At the
FIRST START UP,
make sure that, if the auger
HITCHES
or
BLOCKS
, you can
IMMEDIATELY SWITCH OFF
the system with the main switch on the control panel.
GENERAL SAFETY RULES
IMPORTANT
LINE SYSTEMS
Carefull read the following instructions be-
fore you
INSTALL
the system
This
SYMBOL
will be used to draw your attention to matters that are
of
GREAT IMPORTANCE
for your
SAFETY
.
It means :
WARNING
- follow the safety instructions :
disconnect the current - re-read the safety rules.
In short :
BE ALERT
.
IGNORING these instructions can cause SE-
RIOUS INJURIES or even DEATH.
DANGER