Rowenta BALNEA SO6010 Manual Download Page 8

Page: 8 / 31

Please read carefully and keep in a safe place.

1- WARNINGS

• For your safety, this appliance complies with the applicable standards and regulations or commercial (Low Voltage, Electromagnetic
Compatibility, Environmental Directives, etc.)
• The warranty will be invalid in the event of damage arising from incorrect use.
• Do not place your appliance directly beneath a wall socket.
• Do not operate your appliance in a dusty room or if there is a risk of fire.
• Each time before use, check that in general the appliance is in good condition, as well as the plug and the cord.
• Never insert any objects inside the appliance (e.g.: needles)
• If the power cord is damaged, it must be changed by the manufacturer, the After Sales Service or a similarly qualified person in order to
avoid any danger.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsi-
ble for their safety. Children should be supervised to ensure that they do not play with the appliance.
• Do not pull the power cord or the appliance, even to unplug it from the wall socket.
• Completely unwind the cord each time before use.
• This product has been designed for domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions,
the manufacturer accepts no responsibility and the guarantee will not apply.

2- VERY IMPORTANT

• WARNING: To avoid risk of overheating, NEVER PLACE OBJECTS ON TOP OF THE UNIT.
• Do not use the unit in the proximity of flammable objects or products (curtains, aerosols, solvents, etc.)
• Never use the unit in an inclined or horizontal position.
• Do not use this appliance near a bath, shower, sink or swimming pool.
• NEVER ALLOW WATER TO PENETRATE THE APPLIANCE.
• Do not touch the appliance with wet hands.
• In the event of a long absence: turn the button A (fig.4b/4c) to the initial setting

(SO6020/SO6030) and unplug the appliance

or turn the button B (fig.4a) to the initial setting

(SO6010) and unplug the appliance.

4- VOLTAGE

• Before first use, make sure that the voltage being used corresponds to what is indicated on the unit and that the electrical installation is adapted
to the power level indicated.
• Your appliance can be used with a power plug without an earth connection. It is a class II appliance (dual electrical insulation

5- SAFETY

SO6010/SO6020:

SO6030:

• In the event of abnormal overheating, a safety device shuts down the appliance and then automatically restarts it once ithas cooled. If the fault persists
or gets worse, a thermal fuse shuts the appliance down definitively and it must then be taken to an approved service centre.
• If the unit tips over, a safety device automatically turns it off. When placed back in an upright position, it will once again begin to operate.
In both cases, a warning beep will occur and the "Signal Protect" indicator (D) will light up.

6- OPERATION

Before turning the unit on, make sure:
- it is positioned as described in these instructions,
- that it is placed in a flat and horizontal position, and;
- that the air intake and outlet screens are free of all obstacles.

• Function Selection (SO6020/SO6030):

Select the desired function by turning switch (A) to line up the marking on the switch with one of the following symbols:

: on
: Cooling

• : 1200W
• • : 2400W

• Indicator:

- On/Off indicator (C fig.4), lights up when the unit is turned on.
"Signal Protect" indicator (D fig.4c), lights up in case of overheating or if the unit tips over. Only for Mod.SO6030.

• Thermostat:

Adjust the temperature setting, according to your own comfort, by turning button B (fig.4).

• Frost-free setting

This setting enables you to automatically maintain the temperature above 0°C in a normally insulated room, whose volume corresponds to the power of your
appliance.
SO6010 : To do this, plug in your appliance and turn button B (fig.4a) so that the marker is opposite the “

”.

SO6020/SO6030 : Plug in the unit and turn switch B to line up the marking on the switch with the “

” and turn switch A to select one of the

following: • 1200W or •• 2400W

• Cold ventilation setting

: (SO6020/SO6030)

This setting enables you to use your fan heater as a fan in summer.

3- USE IN THE BATHROOM (protection against splashing with water)

• This “ IP21 “ unit has been specially designed so that it can be used in any room in your house, including those where there is a risk

of water being splashed onto it from above (kitchen, bathroom, etc.).

• However, the electrical installation in the room, the installation of the unit and the way the unit is used must all comply with the

safety standards in force in your country.