Rowe GrandSTAR, Service Manual

Page: 57 / 120

Grand STAR Internet Jukebox LED Lighting and Bill Acceptor
22022603 5-1
Section: 5 LED Lighting and Bill Acceptor
Introduction
LED Control Assembly (#40931103)
The LED Control Assembly in the Grand STAR jukebox supplies all the lighting in the
jukebox. There are no fluorescent bulbs, starters, ballasts, or 12 V peanut lights. All lighting
is supplied by the use of 29 ultra bright LEDs.
As seen from the outside of the cabinet:
•
12 LEDs illuminate the Graphics Panels
•
8 LEDs illuminate the Crown, 2 each of Red, White, Green, and Blue (Black Door)
• 4 LEDs illuminate the Left Pilaster, 1 each of Red, White Green, and Blue (Black Door)
•
4 LEDs illuminate the Right Pilaster, 1 each of Red, White Green, and Blue (Black Door)
•
3 White LEDs illuminate the Service, Left and Right Accent Lighting
Features of the LED Control Assembly (#40931103) (Figure 5-2 )
The features of the LED control are as follows:
1. Flashing rate (speed) of the LEDs
2. Brightness of the LEDs
3. Music
beat sensitivity
4. (Mode) Choice of lights static in standby and beat to the music, or lights flash at
standby and beat to the music.
5.
Choice of three patterns
All features are controllable at the LED Control Assembly and the IR Remote (see
Figure 5-1
). If enabled, and any of the LED Control buttons are pressed, the Red LED
on the IR Receiver flashes when the IR command is acknowledged by the LED
Control. The remote can be disabled if desired-this feature is described in Remote
Enable/Disable Program Switch on page 5-3.
Figure 5-1 – IR Remote
LED CONTROL
BUTTONS