RMS-LOG Wireless / LAN Data Loggers
E-M-RMS-LOG-V1.4.docx
Instruction Manual
© 2018
ROTRONIC AG
Bassersdorf
Switzerland
Page 27 of 35
► Discovery
With Discovery it is possible to find devices in the subnet with
the RMS configuration software irrespective of their IP
configuration and to change their settings.
► IP configuration
The devices can have static or dynamic IP configurations. It is
recommended that you use a dynamic IP configuration
whenever possible.
If fixed IPs are used, the network topology must be considered
exactly.
► RMS Web Server settings
Every device has the server address and software path of the
RMS server software stored in it in order to build up
communication with the RMS server software.
The two parameters can be set with the RMS configuration
software:
Host
: Address of the server with the RMS software
Server path
: Server path where the server software is
installed.
► Measurement by the connected probe
The device recognizes the connected probe automatically and
requests the latest measured data. The measured data are sent
to the RMS server software at the set interval directly after the
measurement.
► Save measured data
The measured values of every measurement are saved in the
internal ring memory (44,000 pairs of measured values). If the
data cannot be sent to the server software directly, they are kept
in the device and then sent later as soon as the connection to
the server software has been restored.
► Battery mode
If the external power supply (24 VDC / PoE) fails, the device
runs in battery mode. Measurements are still carried out at the
set interval and the data saved in the ring memory (44,000 pairs
of measured values).
►Firmware update
The firmware of the device can be updated directly via the RMS
server software.
