-14-
Eventual Errors and problem solutions
Nr.
Error
Cause
Solution
1
Nothing on the display
C1. No voltage
C2. Power supply of the
cooker is damaged.
S1a. Is the connector pluged
in?
S1b. Is the power of the
connector on? (check
fuse, connect any other
device to control the
connector)
S2. Send cooker to service
station.
2
The cooker shows >E1< and
stops after 60 sec.
C1. No applicable cookware
C2. Applicable cookware not
in reach of the sensor
C3. Cookwaresensor damaged
S1. Use applicable cookware
S2. Reduce distance between
plate and cookware
S3. Send cooker to service
station.
3
The cooker shows >E5<
Temperature Sensor is
damaged
Send cooker to service station
4
The cooker stops heating
during operation
Interrupted heating may be found in warming, some lower
power levels and some other functions. This is normal
5
The cooker shows >E6<
C1. Wrong mode pressed
C2. No fl uid in the cookware
S1. If the cookware is too
hot for the select mode,
you may get this error.
Let the cookware cool
down.
S2. Put fl uid in the cookware
6
The cooker shows >E2<
C1. Ambient temperature is
too high
C2. Air inlet or outlet is blo-
cked
C3. Internal temperature is
too high
S1. Use the cooker in another
room
S2. Remove blockade of the
air inlet or outlet
S3. Restart the cooker a few
minutes later
7
The cooker shows >E4<
supplied main voltage is lower
than 170 Volt
Check power source if possible
8
The cooker shows >E3<
supplied main voltage is high-
er than 260 Volt
Check power source if possible
9
The temperature is out of
control during operation
C1. Cookware not placed in
center
C2. Cookeare has a concave
over 2mm
S1. Place cookware in center
S2. Use applicable cookware
10
The fl uid can not be boild
C1. Fluid amount is more than
4 liter.
C2. Cookware bottom is too
large
C3. Ambient temperature is
below 5°C
S1. Turn on Boiling mode and
wait a little bit longer
S2. Use applicable cookware
S3. Try to use a smaller fl uid
amount.
11
The cooker shows >E0<
Electronic damage
Send cooker to service station
