A
B
C
A
B
C
Fig. 12
Fig. 12a
Fig. 12b
11. Power Unit E Series Lifts:
Put (2) 5/16"-18NC x 1-1/2" HHCS through top holes in power
unit bracket using Vibration Pad to hold in place, Fig. 12. Install
5/16"-18NC Flanged Nuts until bolt end is flush with end of nut.
Install power unit onto column extension, Fig. 12a. Slide bolt/
nut combination into top set of holes and down to bottom of slot.
Install HHCS, Vibration Pad, and Flanged HHCS in bottom power
unit holes and tighten. (Be sure to place vibration pad between
power unit and column extension). Tighten top HHCS and Nut.
Install and hand tighten Male Extension to pump until O-ring is
seated, Fig 12b. Continue to tighten the lock nut to 14 - 20Nm
(1.4 - 2.1kg-m), or until the nut and washer bottom out against the
pump manifold.
IMPORTANT
Over tightening lock nut may tear O-ring.
Install Female Swivel Tee To Male Extension, Fig. 12b. Use Flared
Fittings Tightening Procedure to tighten the Female Swivel Tee to
the Male Extension.
12. Flared Fittings Tightening Procedure:
A
B
Flared Fittings Tightening Procedure
1. Screw the fittings together finger tight.
Then using proper size wrench rotate the fitting
2-1/2 hex flats.
IMPORTANT
Flare seat
MUST NOT
rotate
when tightening. Only the nut should turn.
2. Back the fittings off one full turn.
3. Again tighten the fittings finger tight then using
a wrench, rotate the fitting 2-1/2 hex flats. This
will complete the tightening procedure and deve-
lop a pressure tight seal.
IMPORTANT
Over tightening will damage
fittings resulting in fluid leakage.
Fig. 12b Detail
A Install male extension after power unit is
mounted.
B Install Tee after male extension is placed on
power unit.
Note:
DO NOT ROTATE MALE EXTENSION
WHILE INSTALLING TEE.
Fig. 12 Detail
A 5/16"-18NC x 1-1/2" Lg. HHCS
B Vibration Pad
C 5/16"-18NC Flanged Lock Nut
Fig. 12a Detail
A Hang power unit from bolts in top of power unit
bracket.
B Fill Breather Cap
C Insert bottom bolts through holes after power
unit it hung attach flanged lock nut from inside
column.
8
Summary of Contents for SPO54E
Page 2: ...Fig 1 Fig 2 A B C D E F G H I J A B C D E F G H I J 2...
Page 31: ...NOTES...