Fig. 36c
NOTE:
Once arm is installed in yoke, pull up
actuator pin and swing arm fully around, being
sure that the Restraint Gear and Gear Block always
stay aligned. If they do not stay aligned, remove
restraint gear and install in the opposite position.
Fig. 37
A
A
B
B
B
A
NOTE:
To check operation of arm restraints, raise carriage
1” min. from full down position. Pull up on pin-ring and adjust
arms to desired position. To engage restraint, let pin-ring down
allowing gear teeth to mesh together. It may be necessary to
rotate arm slightly to engage gear teeth.
NOTE:
Pin & Ring, Spring, & Gear Block are all preassembled.
Fig. 38
30. Arm Guard Installation:
Install arm guards, Fig. 39.
31. Latch Release Decal For M Series Lifts:
Install latch release
decal on cover above latch release handle, Fig. 40.
32. Door Bumper Installation (All Models):
1.
Press 457mm bumper on column edge,
Fig. 41.
2.
Press 152mm bumper on top front edge and top side of carriage
tube, Fig. 41.
3.
Press bumper back side of carriage between carriage and
column as shown, Fig. 41.
33. Wheel Spotting Dish (All Models):
Position wheel spotting
dish, for appropriate lift model, as illustrated in Fig. 1a, 1b or 2a,
2b. Drill (2) 3/8" holes
2-1/2" deep in concrete floor using holes in wheel spotting dish as
guide. Drive both anchors, provided, into concrete to secure dish.
Attention: For M Series lifts continue to Section 37.
Fig. 38 Detail
A Use holes marked with arrow for Right Front and
Left Rear.
B Use holes marked with arrow for Left Front and
Right Rear.
CAUTION
If not specified
otherwise, use
hardness grade 5 for
any ironware
CAUTION
If specified, use
hardness grade
8 screws
28
Summary of Contents for SPO54E
Page 2: ...Fig 1 Fig 2 A B C D E F G H I J A B C D E F G H I J 2...
Page 31: ...NOTES...