Rotary SPO54E, Installation Instructions Manual, Page: 4 / 32

Attention:
E Series Lifts DO NOT Have Latch Cable Guides
or Locking Latch Cables.
3. Latch Cable Guides for M Series Lifts: Install the latch cable
conduit guide brackets to column extensions with (1) 1/4”-20NC x
1” HHCS and 1/4”-20NC Flanged Lock Nuts, Fig. 4. HHCS should
go through hole nearest the edge as shown, Fig. 4.
4. Column Extensions:
Install the column extensions as shown,
Fig. 5 & 5a. Install Tie Bar as shown, Fig. 3.
Overhead Mounting Bracket:
Install Mounting Brackets to
column extensions, Fig 3.
5. Lift Setting:
Position columns in bay using dimensions shown
in Fig. 1 or Fig. 2. With column lying on the floor, two people can
lift the top of the column and walk towards the base. As the
column approaches vertical, one of the two people should move
to the opposite side of the column and assist in slowly setting the
column flat on its base. Both column base plate backs must be
square on center line of lift. Notches are cut into each base plate
to indicate center line of lift. Using appropriate equipment, raise
carriage to first latch position. Be sure locking latch is securely
engaged.
Note:
For M Series lifts place column with power unit mounting
bracket on vehicle passenger side of lift.
Fig. 5
Fig. 4
Fig. 5a
6. Concrete and Anchoring: Concrete shall have a compression
strength of at least 20N/mm
2
and a minimum thickness of 125mm
in order to achieve a minimum anchor embedment of 95mm.
When using the standard supplied 20mm x 170mm lg. anchors, if
the top of the anchor exceeds 75mm above the floor grade, you
DO NOT have enough embedment. Drill (12) 20mm dia. holes in
concrete floor using holes in column base plate as a guide. See
Fig. 6a and Fig. 6b for hole depth, hole spacing, and edge distance
requirements.
CAUTION
DO NOT install on asphalt or other similar
unstable surfaces. Columns are supported only by anchors in
floor.
Standard
Height
Setting
102mm
Lower
Height
Setting
216mm
Lowest
Height
Setting
4