Installation and Wiring
MD-W11 Installation Manual
15
2.
Use the drilling template to determine where to drill holes in the
wall.
3.
Use the hardware to mount the back plate on the wall.
We highly recommend using the bottom left mounting hole, as
it is acts as a back tamper when a person attempts to dislodge
the unit from the wall (see Figure 2 marked with
A
).
4.
Wire the unit as instructed in Section
3.4.
3.4
Wiring the MD-W11N Unit
Wire the following terminals between the controller's input and
output to the MD-W11N Near Unit, as shown in Figure 3:
Figure 3: Near Unit Wiring Diagram
