16 • Physical Installation
Ultricool User Guide (v1.0)
Connecting Ultricool to a Network
The
ENET
port is a standard 10/100 RJ45 Ethernet connector and is used to exchange data and communicate with
control and monitoring applications such as DashBoard.
Contact your IT department before connecting to your facility network to ensure that there are no conflicts. They
will provide you with an appropriate value for the IP Address, Subnet Mask, and Gateway for your device.
The Ultricool is connected directly to your network so that it can interface with the devices and the computer
running the DashBoard client. After a physical connection is established, DashBoard is used to configure the
network settings for the Ultricool.
For More Information on...
• downloading and installing DashBoard, refer to the
DashBoard User Manual
.
If difficulties or problems are experienced when connecting the Ultricool to a network hub, or with assigning IP
addresses, please contact your network administrator.
To establish a physical connection to the network
1. Connect one free end of a standard CAT 5/5e/6 Ethernet cable to a free port of the network hub.
2. Connect the other end of the same cable to the
ENET
port on the rear of the Ultricool.
Figure 4.1 Ultricool — Network Connection
Connecting to a Power Source
For redundancy, each power cord should be connected to a separate power source for protection against failure of
the A/C power circuit. Under normal conditions with two power supply modules operating, the DC output power is
shared between the two modules.
Warning Hazardous Voltages
— The safe operation of this product requires that a protective
earth connection be provided. This protective earth is provided by the ground conductor in the
equipment’s supply cord. To reduce the risk of electrical shock to operator and service personnel, this
ground connector must be connected to an earthed ground.
Warning
— In some countries it may be necessary to supply the correct mains supply cord. Use only
certified cords for the country of use.
ENET
±15VDC
max.60W
NO
ALARM
C NC
PWR 2
PWR 1
5
6
7
8
1
2
3
4
Summary of Contents for Ultricool
