•
Cancel
— use the
Bank
knob to select the
custom control bank, and the
CC
knob to
select which custom control to cancel
•
CancelAll
— press the
CancelAll
knob to
insert a cancel all custom controls command
•
State
— press the
Insert
knob to insert the
state
4.
Press the
Insert
knob to insert the event.
5.
Press
START/STOP
.
Running a Custom Control
Once a custom control has been programmed, you can
run that custom control by pressing the button that the
custom control was recorded to.
Keep the following in mind when running custom
controls:
•
A custom control will continue to run until it
reaches a hold event, is stopped by another custom
control, you edit a custom control, or the custom
control reaches the end.
•
When a custom control is running, the button on
the custom control bus is red.
•
When a custom control is held (at a Hold event),
the button on the custom control bus flashes white.
•
You can run multiple custom controls at the same
time. The number of running custom controls is
shown on the display when in custom control mode.
•
You can stop a running custom control by pressing
the red custom control button on the custom control
bank.
•
A maximum of 128 custom controls can be run at
the same time.
To Run a Custom Control
Once a custom control has been recorded, you can run
that custom control at any time.
1.
Press
MENU
.
2.
Select the bank that the custom control you want
to run is on by pressing the bank button.
3.
Select the custom control you want to run by
pressing the source button on the custom control
bus.
The custom control starts to play immediately.
Editing Custom Controls
After you have recorded a custom control, you can go
back and edit that custom control to add or remove
events.
To Edit a Custom Control
When editing a custom control, you can delete and insert
events at any point in the custom control, or append
events to the end.
Tip:
When editing a custom control, press RUN EVENT to run
the currently selected event. This can help you diagnose
problems in a custom control.
1.
Press
MENU
>
BANK 1
>
EDIT
.
2.
Use the
Bank
knob to select the bank that the
custom control you want to record will be stored
on, or select the bank button directly.
3.
Use the
CC
knob to select the custom control
that you want to edit, or select the custom control
on the bus directly. The custom control will have
an
*
next to the number.
4.
Use the
Func
knob to select where and how you
want to edit the custom control.
•
Edit
— select the position in the custom
control to edit events
•
Append
— add events to the end of the
custom control
5.
Press the
Func
knob to start editing.
Tip:
You can also start editing a custom control by
pressing and holding EDIT and selecting the bank and
custom that you want to edit to.
The display changes to show the name and
duration of the custom control, and the currently
selected event in the custom control.
6.
Delete an event in a custom control as follows:
a)
Use the left knob to select the event you want
to delete. You can also use the
PREV
and
NEXT
buttons.
b)
Press
DELETE
.
7.
Insert an event into a custom control as follows:
a)
Use the left knob to select the event you want
to insert an event before. You can also use
the
PREV
and
NEXT
buttons.
b)
Press
INSERT
.
c)
Insert the events you want.
Carbonite Operation Manual (v10.1) — Custom Controls •
57
