Rosemount 8732E, Quick Installation Manual

Page: 20 / 60

Quick Installation Guide
00825-0100-4662, Rev CB
July 2011
Rosemount 8732
20
Sensor to Integral Mount Transmitter Connections
Cover Jam Screw
For transmitter housings shipped with a cover jam screw, the screw should be properly
installed once the transmitter has been wired and powered up. The cover jam screw is
intended to disallow the removal of the transmitter cover in flameproof environments without
the use of tooling. Follow these steps to install the cover jam screw:
1. Verify that the cover jam screw is completely threaded into the housing.
2. Install the transmitter housing cover and verify that the cover is tight against the housing.
3. Using an M4 hex wrench, loosen the jam screw until it contacts the transmitter cover.
4. Turn the jam screw an additional 1/2 turn counterclockwise to secure the cover.
(Note: Application of excessive torque may strip the threads.)
5. Verify that the cover cannot be removed.
Step 7: Basic Configuration
Once the magnetic flowmeter is installed and power has been supplied, the transmitter must
be configured through the basic setup. These parameters can be configured through either
a local operator interface or a HART communication device. A table of all the parameters are
on page 22. Descriptions of the more advanced functions are included in the comprehensive
product manual.
Figure 17. Integral Mount Wiring Diagram
Electronics
Board
Do not connect AC
power to the sensor or
to terminals 1 and 2 of
the transmitter, or
replacement of the
electronics board will
be necessary.
NOTE
Interconnecting cables for integral mount transmitters are wired at the factory. Do not
use cable other than that supplied by Emerson Process Management, Rosemount, Inc.
4662RevCBQIG.fm Page 20 Wednesday, July 6, 2011 3:41 PM