Rosemount 8732E, Quick Installation Manual

Page: 19 / 60

Quick Installation Guide
00825-0100-4662, Rev CB
July 2011
Rosemount 8732
19
Remote transmitter installations require equal lengths of signal and coil drive cables.
Integrally mounted transmitters are factory wired and do not require interconnecting cables.
Lengths from 5 to 1,000 feet (1.5 to 300 meters) may be specified, and will be shipped with
the sensor.
When connecting the remote cables, be sure to connect the signal cables (20 AWG) to
terminals 17, 18 and 19. The coil drive cable (14 AWG) should be used to connect terminals
1, 2 and ground. Table 8 below shows the required wiring connections. Figure 16 shows the
terminal block connections at the sensor and transmitter.
Table 8. Remote Wiring Connections Using Individual Coil and Signal Cable
Sensor to Remote Mount Transmitter Connections
Table 7. Cable Requirements
Description Length Part Number
Signal Cable (20 AWG) Belden 8762, Alpha
2411 equivalent ft
m
08712-0061-0001
08712-0061-0003
Coil Drive Cable (14 AWG) Belden 8720,
Alpha 2442 equivalent ft
m
08712-0060-0001
08712-0060-0013
Combination Signal and Coil Drive Cable (18
AWG)
(1)
(1) For remote mount installations, combination signal and coil drive cable should be limited to less than
330 ft. (100 m)
ft
m
08712-0752-0001
08712-0752-0003
Transmitter Terminal Sensor Terminal Wire Gauge Wire Color
1 1 14 White
2 2 14 Black
Ground Ground 14 Shield
17 17 20 Shield
18 18 20 Black
19 19 20 White
Figure 16. Remote Mount Wiring Diagram
Do not connect AC
power to the sensor or
to terminals 1 and 2 of
the transmitter, or
replacement of the
electronics board will
be necessary.
4662RevCBQIG.fm Page 19 Wednesday, July 6, 2011 3:41 PM