Rosemount 8732E, Quick Installation Manual

Page: 11 / 60

Quick Installation Guide
00825-0100-4662, Rev CB
July 2011
Rosemount 8732
11
3. Place the sensor between the flanges. Make sure that the centering rings are properly
placed in the studs. The studs should be aligned with the markings on the rings that
correspond to the flange you are using.
4. Insert the remaining studs, washers, and nuts.
5. Tighten to the torque specifications shown in Table 4 on page 11. Do not overtighten the
bolts or the liner may be damaged.
Flange Bolts
Tighten flange bolts in crosswise sequence. Always check for leaks at the flanges after
tightening the flange bolts. All sensors require a second torquing 24 hours after initial flange
bolt tightening.
Table 3. Stud Specifications
Nominal Sensor Size Stud Specifications
0.15 – 1 inch (4 – 25 mm) 316 SST ASTM A193, Grade B8M Class 1 threaded mounted studs
1.5 – 8 inch (40 – 200 mm) CS, ASTM A193, Grade B7, threaded mounting studs
Figure 7. Gasket Placement with Centering Rings
Table 4. Rosemount 8711 Torque Specifications
Size Code Line Size Pound-feet Newton-meter
15F 0.15 inch (4 mm) 5 7
30F 0.30 inch (8 mm) 5 7
005 0.5 inch (15 mm) 5 7
010 1 inch (25 mm) 10 14
015 1.5 inch (40 mm) 15 20
020 2 inch (50 mm) 25 34
030 3 inch (80 mm) 40 54
040 4 inch (100 mm) 30 41
060 6 inch (150 mm) 50 68
080 8 inch (200 mm) 70 95
Centering
Rings
Installation,
Studs Nuts
and Washers
Customer-supplied
Gasket
FLOW
4662RevCBQIG.fm Page 11 Wednesday, July 6, 2011 3:41 PM