Rosco Vision SAFE-T-SCOPE 360, Installation Manual And User'S Manual

Page: 21 / 29

21
Device Operation
General Information
•
This system is meant to supplement vehicle mirrors and other vision aids, NOT to replace them.
•
Always be aware of all surroundings when operating a vehicle.
Power/Channel Button Harness
•
The system can be manually triggered using the included Power/Control Button harness.
•
Car Icon Button cycles through 9 views shown on Page 22. Note that system triggering (see next section) will
override manual view selection via Car Icon Button.
•
Power/Setup button turns on/off CVBS output-it does NOT affect CVBS-RV output. CVBS-RV output is always
on.
Triggering
•
Once system is installed and set up, triggering will occur automatically.
•
Default triggers are reverse gear, right turn signal, and left turn signal. With this configuration, emergency
lights can trigger a fourth state.
•
Default or custom triggers should be specified upon purchase-the ECU will come pre-set with any required
custom triggers.
•
Blue trigger wire (reverse trigger) is the highest priority trigger. Orange (left flasher) or Brown (right flasher)
will always be overridden by Blue.
•
Orange (left flasher) PLUS Brown (right flasher) will trigger “emergency light” scenario. This trigger can be
independently programmed to any of the 9 available views.
•
If you do not plan to use the default trigger configuration, triggering from door switches or other sources is
possible.
•
See Wiring Overview section (Page 9) for detailed information on trigger wire installation and options.