Rosco Vision SAFE-T-SCOPE 360, Installation Manual And User'S Manual

Page: 19 / 29

19
•
Once pattern placement has been verified, press, and hold the vehicle icon on the wired remote. The display
will show “Saving Camera image…” Release the button. Wait several minutes until image capture is
complete.
•
Wait until “Finish to Save image (OK)” and “Safe to pull out SD card” are displayed. Push in SD card to remove
it from calibration module. Disconnect calibration module from ECU. Vehicle ignition can now be shut off.
•
Insert SD card into card reader or computer SD card slot.
•
Open SD card on computer
o
Verify that “Image” folder h as 4 images (front.bmp, left.bmp, rear.bmp, and right.bmp).
o
Open the 4 images
o
Verify that two triangles are fully visible in each image.
o
If additional markers were used, verify that they are visible as well.
o
Verify that edge of vehicle and/or bumper are at least partially visible in all images.
•
Share images with a certified Rosco Engineer:
o
Contact Rosco Tech Support at techsupport@roscovision.com or (718) 526-2601 to create a
calibration request.
Calibration Upload Procedure
•
Once Rosco engineers receive the necessary calibration images, they will perform software calibration and
return a complete calibration suite. All necessary files will
be within a folder called “ovNS.”
•
Reformat SD card. Copy and paste the new “ovNS” folder from Rosco engineer to root of SD card.
•
This new “ovNS” folder will contain the full calibration suite (“cmd,” “Config,” “data,” “image,” and “param”
folders).
•
DO NOT MAKE ANY CHANGES TO ANY FOLDERS OR THEIR CONTENTS.
•
With vehicle power off, carefully connect the Calibration Module to the port marked “CALIBRATION” on the
ECU.
•
Power on the vehicle.
•
A banner will appear at the top of the display and prompt the user to insert an SD card (see below image).