Rosco Vision SAFE-T-SCOPE 360, Installation Manual And User'S Manual

Page: 9 / 29

9
General Wiring Guidelines
•
Make sure red wire from STSH360PHAR is secured to the vehicle fuse block at a terminal which will be at
zero-voltage state when the vehicle ignition key is OFF. A typical location on a fuse block would be the ACC
port for cigarette-lighter power. Zero-voltage state should be verified using a voltmeter prior to installation.
•
Please refer to vehicle manual and fuse block diagram to identify best location for power, ignition, and
ground wire connection points.
•
DO NOT insert a fuse into Battery or Ignition fuse holders until system is fully installed.
•
It is essential that appropriate external 3-Amp fuses be used for Battery and Ignition wires on STSH360PHAR.
•
If passing front camera cable through the fire wall, be sure to seal any holes in fire wall.
•
Use caution when working around vehicle engine. Be aware of hot components. Take care to properly shield
all cables from any hot components.
•
DO NOT install front camera harness near rotating components.
•
Always make sure vehicle engine is OFF when installing front camera.
•
Tape/cap any unused wires.
Wiring Overview
•
See the following sections for more detail on STSK360PHAR and STSK360VHAR
•
See section “Application Notes” on Page 28 for detailed system drawings that include a monitor
.
EXAMPLE:
Ground Wire Ring
Terminal connected to the
vehicle chassis ground
EXAMPLE:
Fuse Holder/Add-a-Fuse
for Ignition and Battery
connections