10
Mounting the Dual-Vision™ XC Recorder
IMPORTANT
Installation of permanent mounting should only be done when windshield is at room
temperature. Allow 2-4 hours for adhesive bond to cure properly before operating vehicle.
8.
To permanently set the Recorder mounting position and the camera angle, insert screws into
the two bracket mounting holes using a screwdriver, as follows:
1.
Remove the Recorder from windshield
mount, using care to avoid changing
the angle.
2.
Remove the Recorder from windshield
mount, using care to avoid changing
the angle.
Two Screws:
#6 x ½” Self Drilling,
Philips Pan
3.
With the camera angle now locked into
position by the screws, re-insert the
Recorder into the Windshield Mounting
Bracket and press the lock button to
secure the Recorder in the windshield.
9.
Connect Recorder cable to the PDC Module cable. For
most vehicles, this connection will be made within the
overhead space, and will be covered by the headliner.
For additional security, or for installations on very large
windshields, a heat shrinkable tube is provided for sealing
the connection point. Cover exposed cable with included
cable raceways as needed – cut raceways to size.
10.
Check all of your connections and confirm the following LCD
display status after parking surveillance mode is activated
(see Page 17 for details):
a.
After ignition is turned off, a blinking LCD will indicate
parking surveillance is operational.
b.
If LCD does not blink, surveillance mode is not active.
Heat Shrinkable Tube
From Recorder
From PDC Module
